When END is displayed, to exit program data entry push
►
key.
The display shows the current kiln temperature.
No indicators lit on the mimic panel and the run indicator is off
Note 1: to exit programming without cycling through all of the
above steps wait 10 seconds without pressing any keys - the ST215
will revert to the idle display.
Alternatively press the
▶
key to exit programming and to begin
firing immediately
Note 2: the
◄
key can be used to reverse through the
programming steps to correct errors or to exit programming
mode.
Note 3: If the controller remains idle for 10sec it will autonatically
exit the programming mode. Any changes made are automatically
saved.
6.7 Altering, Reviewing a program
To Alter/ Review a program we follow the same procedure as
entering a new program.
6.8 Program Start
To start a program press the
►
key
.
A program number will be displayed.
The required firing program can now be
selected with the
▲
&
▼
keys
.
When the desired program number is
displayed push
▶
to start
Display will show program start
delay time
At this point, you can program your kiln to start firing at a future
time, when you will not be in your studio to start a firing.
22
