AHD-CUC Universal CAN Converter
Disassembly
V3
33
10 Disassembly
After the device has reached its end of life, it must be disassem-
bled and disposed in an environmentally safe manner.
10.1 Safety
Personnel
Only a specially trained professional may perform the disas-
sembly.
Only electricians may work on the electric system.
Basic Information
Caution!
Risk of injury from improper disassembly!
Stored residual energies, edged parts, points and
corners on and inside the device or the required
tools can cause injury.
Therefore:
– Ensure sufficient installation space before be-
ginning any work.
– Use caution when handling parts with exposed
sharp edges.
– Observe orderliness and cleanliness in the work
area! Parts and tools that are loosely stacked or
lying about are accident sources.
– Uninstall parts properly.
– When in doubt, consult the manufacturer.
10.2 Disassembly
Before beginning disassembly: disconnect the device from the
power supply and secure it against reconnection
Disconnect the cable connections and mark them, if necessary.
Secure free wire ends against short circuit and earth/ground
fault.
Loosen the device mountings.
Uninstall the device through proper measures.
Clean and disassemble the device for selection according to
workplace safety and environmental protection regulations.
