LOOPER THREADING
To simplify the threading of the looper, just tie off
both thread ends with a knot, and then continue
pulling the thread through the thread rod eye and
the tensioner. Continue pulling the thread end
through all eyelets and through both looper eyes.
Leave a six inch tail past the looper, or...
1. Remove the black knob from the empty spool by
twisting it counter-clockwise.
2. Replace the empty spool with the new spool.
(Fig. 1B)
3. Screw the black knob clockwise to the threaded
rod, tighten knob snuggly.
4. Put thread end through the eye of the thread rod
above the spool. (Fig. 1A)
5. Continue threading through the thread tensioner,
then through the eyelet below it.
6. Remove the tape guide bracket by loosening the
two allen screws with the 5/32 allen wrench two
full turns only. (Fig. 1D)
7. Lift up on the folder bracket and set it aside. Put
the thread through the front casting eyelet and
through the take up eyelet, then through the
looper eyes.
8. Leave a 6 inch tail past the looper.
9. Replace the tape folder bracket and tighten
screws snuggly.
You are now ready to bind.
- 4 -
