WARNING
PERSONAL INJURY MAY RESULT IF THE
FOLLOWING SAFETY PRECAUTIONS ARE
NOT OBSERVED.
1.
BE SURE THE AREA SURROUNDING MACHINE
IS FREE OF ALL HAZARDS SUCH AS FIRE, WATER,
OIL, RUBBISH OR ANYTHING THAT CAN CAUSE
INJURY.
2.
DO NOT OPERATE MACHINE IN AN EXPLOSIVE
AREA OR UNDER WET CONDITIONS. THE MACHINE
IS NOT AN EXPLOSION PROOF TYPE, NOR WATER-
PROOF TYPE.
3.
DO NOT OPERATE MACHINE BEFORE READING
INSTRUCTION MANUAL.
4.
DO NOT OPERATE MACHINE ON VOLTAGES
OTHER THAN SPECIFIED FOR THE MACHINE.
5.
BE SURE MACHINE IS CONNECTED TO
BUILDING ELECTRICAL SAFETY GROUND (EARTH).
6.
BE SURE POWER (AND AIR SUPPLY) IS OFF
BEFORE PERFORMING MACHINE MAINTENANCE,
PARTS REPLACEMENT, ADJUSTMENTS OR
CLEANING.
7.
DO NOT OPERATE MACHINE WITH GUARDS
AND COVERS REMOVED.
8.
DO NOT TOUCH KNIFE, NEEDLE, PULLEY, BELT
AND MOVING PARTS WHEN MACHINE IS IN
OPERATION.
9.
BE SURE MACHINE IS PLACED ON A SMOOTH
(LEVEL) SURFACE WHEN PERFORMING
MAINTENANCE, PARTS REPLACEMENT,
ADJUSTMENTS, CLEANING OR STORAGE.
10. BE SURE THE MATERIAL TO BE SEWN OR
CLOSED COMPLIES WITH THE MACHINE
SPECIFICATIONS.
11. DO NOT USE SPARE PARTS OTHER THAN
“BOND” GENUINE PARTS.
Identifying and Ordering Parts
Where the construction permits, each part is
stamped with its part number. On all orders,
please include part number, part name and
model name of machine.
(SAMPLE: PBB203081 Looper)
Safety Rules
To prevent personal injury:
•
All power sources to the machine must be
turned off before threading, oiling, adjusting
or replacing parts.
•
All cover and guards must be in position
before operating machine.
•
Do not tamper with safety cover, guards,
etc., while machine is in operation.
Cautions When Using the Machine
Safety Precautions
1) Always turn power off before threading,
oiling, and adjusting the machine or
replacing parts.
2) Wear safety glasses.
3) Make sure before starting the machine that
all covers and shields are in place and
closed.
Maintenance
•
Please keep in mind to handle the machine
carefully and to maintain the machine in
good condition.
•
Thread fuzz or dust must be cleaned with air
or brush on throat plate, in the groove of
feed dog or around looper after the day’s
work.
•
Wipe the area easy to rust with oil cloth.
•
Check the machine for loose screws and
tighten them, if any, once a month.
•
Good maintenance will prolong the machine
life.
i.
