- 21 -
Preparations for treating each patient
1.
Remove, clean, and sterilize all used ultrasonic inserts.
2.
Make sure the scaling insert/tip has been sterilized before treating the next patient.
3.
Clean and disinfect the surface of the power cord, hand piece, and cable assembly.
Daily shutdown
1.
Use the power switch to turn the KRUUSE-SP1 off.
2.
Close the water supply valve.
Daily Maintenance
The suggestions below will help maximize the lifespan of the scaler.
A. The KRUUSE-SP1 should be used in a well-ventilated room
B. Handle the KRUUSE-SP1 with care when moving it.
C. Before leaving the operation room, make sure that the KRUUSE-SP1 is turned off and the
water faucet is tightly closed.
D. If you find that the power output to the hand piece is insufficient, the insert is probably worn
out. Inserts should typically be replaced after six months or when worn out.
E. Please contact a local authorized agent for technical support.
Section IX: Troubleshooting
While Bonart offers repair service, the following trouble shooting procedures can help you save
time.
9-A Troubleshooting Guide
Basic procedures:
1.
Check all lines and connections to and from the system. A loose plug or connection is the
most common cause of problems.
2.
Check the setting of all control knobs.
System will not operate:
LED power indicator is not lit
1.
Check that the three-prong power plug is fully seated in the AC receptacle on the back of the
KRUUSE-SP1, and that the voltage is supported.
2.
Check that the power plug is plugged into the wall outlet.
LED power indicator is lit
1.
Check that the footswitch connector is fully seated in the foot control receptacle on the back
