Bompani BOWM114/E, Washing Manual

Page: 11 / 24

11
SM3017
CONTROL PANEL
EN
ANTI-CREASE: Activating the anti-crease option is done by the G button. The wash-
ing machine will adjust the wash parameters to decrease the chance of creases
forming, making ironing easier.
The spin speed is automatically set at 500 rev/min.
START/PAUSE: When programs and wash options are being selected, the start LED
remains off. To confirm your selection and start the wash cycle, press the
H button.
The LED turns on. During the wash program in progress, the cycle can be stopped
by pressing the
START/PAUSE button for a couple of seconds.
At this point, the wash program stops and you can make changes to the wash op-
tions (enabled depending on which stage of the wash cycle you are in). If the water
temperature is below 50°C, the door can be opened (about 2 minutes after enabling
DISINFECTING THE DRUM
: Frequent washes at low temperatures may encourage the for-
mation of mildew and unpleasant odours inside the washing machine. The DRUM DISINFECTION
function thoroughly cleans the machine with a special cycle at 90°C.
DRUM DISINFECTION automatically recommends, through the blinking of the abbreviation
on
the display, that you start the cleaning program after a certain number of washes, if high temperature
cycles have not been selected during the period.
Remove all laundry from the drum, put the knob I on the
DRUM DISINFECTION program and press
the start H button to start the cycle.
The DRUM DISINFECTION program can be performed at any time or when conditions require it.
Empty the washing machine drum and close the door.
Put the knob I on the DRUM DISINFECTION program, keep the button
pressed until the ab-
breviation appears on the display. Press H to start the DRUM DISINFECTION cycle.
N.B. if, during a pause, no operation is carried out, the wash phase will restart automatically after
5 minutes.
CONTROL LOCK (child safety lock): to activate the control panel lock, simultaneously press the B-E
(lock symbol) buttons; three horizontal lines will appear on the display.
If, during the wash cycle or at the end of the cycle, you wish to reactivate the controls, press buttons
B-E simultaneously, until the three horizontal lines disappear.
EASY LOGIC: The EASY LOGIC automatically adjusts washing time, water and energy consumption
based on the actual amount of laundry loaded in the machine.
The 1/2 load function is unnecessary as the EASY LOGIC system automatically sets the wash
parameters.
the pause function) to load/empty any laundry.
To re-enable the wash phase press the
START/PAUSE button again.