4-ASSEMBLING OF THE TRAY (DESK)
–
1
Handle the tray from both sides, there are
handles located under the tray for
positioning of the tray (b), press them. Slip
over the tray to the rails on the lower part of
the arms of the baby high chair (c) and
move the tray to the required position. Push
the tray in direction of the back support. The
tray can be positioned in 3 positions. Make
sure that the warning triangle is not visible
because in such case, this would indicate
that the tray is not set up correctly. For
correct assembling repeat the procedure
above. If it is assembled correctly, you
should hear the click of the safety clip. After
reaching the selected position, release the
handle again.
Warning:
Always make sure that the tray is pushed sufficiently into the baby high chair. The
numerals on the upper part of the upper side of the hand grips indicate the position of the
tray.
NEVER
use the tray, if you can see the symbol of the warning triangle. Before each
use, always check the safety of the tray in a way that you pull it slightly outside.
4-DISMANTLING OF THE TRAY
–
2
The upper part of the tray may be
dismantled in a way that you pull the side
hand grips d), e) and move the tray up.
Such removed part can be used as a
serving tray or a tray placed on the table. In
order to mount the tray again put the upper
part to the same place and press the side
hand grips until you can hear a click of the
safety clip.
If you do not use the tray, you can hang it on the
back legs of the baby high chair.
Hang the tray on the back legs in a way that you
hang it through the stoppers located on the back
legs. There are holes on the lower part of the
tray in which the stoppers might be placed. After
assembling, press the tray down so that it
properly slides into the slots. For dismantling
pull the tray up and dismantle it from the
stoppers.
4-HANGING THE TRAY ON THE BACK LEGS
–
3
