3-POSITONING OF THE BACK SUPPORT
–
1
The back support has 3 tilting positions.
In order to set the required position, press the handle on the back side of the back support
(b) and tilt the rest to the required position, then release the handle again. If the back
support is set up correctly, it should fit in the right position. The back support should be
placed into one of 3 sets of slots in the back part of the arm rest (4).
WARNING: Do not position the height of the seat when a child sits in the seat.
In order to position the height of the seat, press the buttons placed at the back side of both
stoppers intended for positioning of the height of the seat (a).
Move the seat up or down, depending on the position you wish to set up the seat for. The
seat may be set in 6 positions, 1st position is the highest. After reaching the required
position, release the stoppers again. Before placing the child in the chair, make sure that
the height is set up in the same way also for both legs and that the stopper properly fits into
the hole in the leg of the chair.
3-POSITONING OF THE HEIGHT OF THE SEAT-2
BASKET
The child high chair can be equipped with a basket for small objects (DD, 26, 27).
If you wish to fasten it to the frame, proceed accordingly:
Put the metal ends of the basket to the respective place on the chair frame
Wind the straps with Velcro round the metal pole under the seat.
In order to take off the basket, repeat the procedure above in the reversed order.
