Page 34 of 35
ASSEMBLY OF OPTIONS – Roll-bar
Drill the 2 x 2 holes in the rear
transom, using the template as
drilling guide.
On the port side, you can proceed in
this way, or drill the transom from
the inside of the ship, using the roll
bar as a guide, after locating it
correctly and holding it.
THE HOLES MUST BE PERPENDICULAR TO THE TRANSOM PANEL.
Mark the position of the axis of the holes previously
drilled on starboard.
Reproduce this axis as shown on the photo opposite.
Drill a hole, dia. 6 mm
min., on the axis
just reproduced.
Drill a hole, dia. 50 mm
or slightly larger,
axis traced.
45 mm
Hole on starboard to
attach the roll bar
Hole, dia. 50 mm,
tangent to the inner
wall.
Hole needed to locate
the position of the inner
wall
Summary of Contents for SUNRIDER 500
Page 103: ...Seite 28 von 36 ...