Bomar Ergonomic 320.250 DG, Operating Instructions Manual

Page: 35 / 115

35
Ovládá
ní str
o
je
Bedi
en
ung
der
Masch
ine
Machine control
angle < 0°
angle ≥ 0°
4. Shift the vice according to setting angle of
the cutting. Shift the vice to the right for
angle of the cut, which is less than 0°, shift
the vice to the left for angle of the cut 0° or
for angle of the cut, which is bigger than 0°
3.4. Material insertion
•
Never walk under a suspended load!
•
Never climb onto the gravity-roller conveyor!
•
Do not hold the material for clamping material to the vice! The vice can cause
injury!
3.4.1. Handling agent selection
•
Use the strong handling agents to lift and transfer the material!
•
Handle with the material only with the lift truck or use the suspension strands and
the crane!
•
Do not use the lift truck or crane in case that you do not have the license to handle
with it!
3.4.2. Insertion
Insert material to the vice and ensure that the material cannot move in the vice or fall
from the vice after the clamping. If you cut long pieces of the material (for example rod,
tube), you must use the roller conveyors for material shifting to the band saw. Contact
Bomar for more information about roller conveyors
Make sure the conveyor is long enough and the material cannot tip off the conveyor.
Be especially careful with round materials that it always stays on two vertical rollers and
that it cannot fall off the conveyor!
3.4.3. Bundle material cutting
If you want to cut the material in the bundle, there are suggestions for the positioning
of bundles
Round material bundle: Take care especially with round material that the bars are put
according to the picture. If the bars are put differently, you may have problems with
movement.