BOMANN VS 7329, Instruction Manual

Page: 21 / 28

21
•
Detach the door contact switch from the hinge
cover and insert it into the delivered hinge cover.
• Dismount the upper door hinge and lift out the
appliance door.
•
Remove the door stopper on the door underside
and attach the delivered door stopper to the other
door underside.
•
Tilt the device slightly backwards and block it in
this position. Unscrew the feet and dismount the
lower door hinge.
• Transfer and attach the lower door hinge to the
opposite device side; after you have unscrewed
the hinge pin and inserted it into the adjacent ho-
le. Screw in the feet accordingly.
•
Put the device back in the upright position. Loo-
sen the screw cover on the device top and reat-
tach it on the other side.
• Put the appliance door on and fix it in the inten-
ded position.
•
Check the door rubber seal for an exact fit and, if
necessary, bring it into the correct position.
•
Move the cable on the device from the right to the
left slot.
•
Transfer and fasten the upper door hinge on the
opposite device side; after you have unscrewed
the hinge pin and inserted it from the other side of
the hinge.
•
Lay the connection cable through the hinge ope-
ning. Put on the hinge cover, connect the display
and door connector and screw on the hinge co-
ver.
• Turn the blind cap (a) about 180° and insert it.
• Dismount the door handle (if it is already installed)
and attach it to the corresponding other outside of
the door. Observe the instructions under "As-
sembling the door handle". Move the cover caps
to the exposed holes on the other door side.
Check that the door is optimally aligned vertically
and horizontally so that the door can open and
close smoothly.
Startup / Operation
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter “Cleaning and Maintenance”.
Control panel
NOTE:
About 2 minutes after the last button press, the dis-
play will enter the standby mode.
The standby mode is terminated as soon as buttons
are pressed, or device door is opened.
Control lamps
Temperature display
Super cooling function activated
Vacation mode activated
Control panel locked for operation
Function buttons
FRIDGE: Temperatue setting
Allows you to regulate the inside temperature in the
range of +2°C to +8°C.
SUPER: Super cooling
Activate/deactivate the super cooling function.