76
NOTE
NOTE
NOTE
NOTE::::
Check after each rinsing the filter for residues.
•
Turn the filter system counterclockwise and
remove it upwards.
•
Remove the micro filter as from the main filter.
•
Remove leftover food and clean the filter under
running water. Use a soft brush for the coarse
and micro filter, if necessary.
•
Reinstall the filter system in reverse order.
Cleaning the
Cleaning the
Cleaning the
Cleaning the lower
lower
lower
lower spray arm
spray arm
spray arm
spray arm
Lime and impurities from the
rinsing water can block nozzles
and bearings of the spray arm.
Check the outlet nozzles of the
spray arm regularly for block-
ages.
•
Pull off the lower spray arm upwards.
•
Clean the arm under running water; if neces-
sary use a soft brush for the nozzles.
•
Insert the spray arm again until they click into
place.
Maintenance of the di
Maintenance of the di
Maintenance of the di
Maintenance of the dishwash
shwash
shwash
shwasher
er
er
er
C
C
C
CAUTIO
AUTIO
AUTIO
AUTION
N
N
N::::
Never use spray cleaners to clean the door panel,
this may damage the door lock and electrical com-
ponents.
•
Clean the appliance outer surfaces and the
door sealing thoroughly with a soft, damp cloth.
Use only mild cleaning agent.
•
Use to remove stains inside the appliance a
dampened cloth with a little white vinegar or a
special detergent for dishwashers. If necessary,
fill detergent in and start the appliance without
dishware in the program with the highest rinse
temperature.
•
Recommendat
Recommendat
Recommendat
Recommendation
ion
ion
ion: allow the appliance to run
regularly without loading in the program [Self-
Cleaning].
•
Dry the outer surfaces thoroughly before taking
in operation again.
A
AA
Antifreeze
ntifreeze
ntifreeze
ntifreeze protection
protection
protection
protection
If the unit is out of operation and exposed to tem-
peratures below zero, observe the following pre-
cautions:
•
Disconnect the mains plug.
•
Close the water supply and remove the inlet
hose from the water valve.
•
Drain the water from the inlet hose and the
water valve.
•
Reconnect the inlet hose to the water valve.
•
Turn off the lid of the salt container and take off
the filter system. Remove the remaining water
in the sump with an absorbent sponge.
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Before you contact an authorized specialist
Before you contact an authorized specialist
Before you contact an authorized specialist
Before you contact an authorized specialist
Problem
Problem
Problem
Problem
Possible cause / Action
Possible cause / Action
Possible cause / Action
Possible cause / Action
Unit doesn’t
start
∙ Check the power supply. ∙ Is the
unit turned on and the door securely
closed? ∙ Is a program selected?
∙ Is the water supply properly con-
nected and the water supply opened?
Water is not
drained off
∙ Check the drain hose. ∙ Are the
filters or the kitchen sink clogged?
Noise
∙ Make sure that all dishes are se-
cured in the dishwasher. ∙ Place the
parts so that the spray arms can
rotate freely.
