9
NOTE:
Remove spilled rinse aid with an absorbent cloth to
avoid excessive foaming during the next rinse.
Adjusting the rinse aid dosage
When forming spots and the dishes dries poorly,
increase the added amount of rinse aid. You can set
the amount of addition between level 1 (min.) and
level 6 (max.).
Take off the lid of the rinse aid dis-
penser and adjust the dial to the de-
sired level. The factory setting is “4”.
NOTE:
Increase the dosage if there are drops of water or
lime spots on the dishes after rinsing. Reduce the
dosage if there are sticky whitish stains on dishes or
a bluish film on glassware or knife blades.
C. Fill in detergent
Function of detergent
Detergents with its chemical ingredients are neces-
sary to remove dirt, crush dirt and transport it out of
the dishwasher. The most commercially, high-quality
cleaning agents are suitable for this purpose.
Detergent
Normally new pulverized detergent is without phos-
phate. Thus, the water softener function of phos-
phate is not given. In this case we recommend filling
salt in the salt container even when the hardness of
water is only 6°dH. If detergents without phosphate
are used in the case of hard water often white spots
appear on dishes and glasses. In this case add more
detergent to reach better results. Detergents without
chlorine do only bleach a little. Strong and colored
spot will not be removed completely. In this case
choose a program with a higher temperature.
Detergent tablets (Tabs)
Dishwasher tablets from different manufacturers
dissolve at different rates. It is possible that they will
not fully dissolve in programs with short running time
and low water temperature and thus does not reach
their full productive efficiency. To ensure the com-
plete removal of detergent residues, we recommend
choosing rinse programs with long running times and
high-water temperature. Always follow the manufac-
turer's instructions!
Fill in the detergent
NOTE:
Always add the detergent just before starting the
rinse cycle, otherwise it could get damp and will
not dissolve properly.
You’ll find information about the amount of deter-
gent for the respective programs in the „Program
table“.
Note that depending on the degree of soil-
ing and water hardness differences are possible.
At the end of the rinse cycle the detergent dis-
penser must be empty.
The dispenser must be refilled before the start of
each rinse cycle according to the instructions in the
"Program table".
Press the release button to open the dispenser.
A
Chamber of detergent in powder form for the
main rinse
B
Chamber of detergent for the pre-rinse /
Chamber for detergent in tablet form
The main rinse chamber must be filled at least up
to the marking MIN
.
Add with heavily soiled dishes an additional dose
of detergent in the chamber for the pre-rinse.
Close the dispenser. Make sure that the lid locks
into place.
