BOMANN GSP 7401, Instruction Manual

Page: 7 / 20

7
Notes on inlet hose safety system (delivery scope
Notes on inlet hose safety system (delivery scope Notes on inlet hose safety system (delivery scope
Notes on inlet hose safety system (delivery scope
depending on model)
depending on model) depending on model)
depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop,
www.bomann www.bomann www.bomann www.bomann----germarny.de germarny.de germarny.de germarny.de . To order, use the
reference number found under “Technical Data”.
Connect the water inlet hose (cold water connection) Connect the water inlet hose (cold water connection) Connect the water inlet hose (cold water connection) Connect the water inlet hose (cold water connection)
NOTE
NOTE NOTE
NOTE::::
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.
•
Connect the water inlet hose to a
water thread with ¾“. Screw the
hose firmly in the direction of the
screw thread; pay attention for a
tight fit.
•
Connect the other end of the inlet
hose to the inlet valve on the appli-
ance back; pay attention for a tight
fit too.
Connect the water drain hose Connect the water drain hose Connect the water drain hose Connect the water drain hose
NOTE
NOTE NOTE
NOTE::::
The drain hose has a length of approx. 1.5 m and
can extend with a suitable hose and connecting
piece to a length of max. 4 m.
CAUTION: CAUTION: CAUTION: CAUTION:
To prevent backflow of contaminated water, the free
end of the hose must not come under the water level
of the drain.
•
Connect the drain hose to a
drain pipe (B) with a mini-
mum diameter of 40 mm;
alternative the drain hose
can be fixed directly to the
sink (A).
•
Always make sure that the hose is not bent or
squeezed.
•
The drain hose may be installed up to a height of
1000 mm above the rinsing floor.
•
Secure the drain hose securely to avoid a change
in position and with it a water leakage.
Electrical connection Electrical connection Electrical connection Electrical connection
WARNING:
WARNING: WARNING:
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric
electric electric
electric
shock shock shock shock!
•
Do not use multiple sockets or extension cords.
•
It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
•
The accessibility of the power plug must always
be ensured to disconnect the device from the
power supply in case of an emergency.
•
Make sure that the voltage supply matches the
specifications on the rating label (door frame) be-
fore connecting.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Prior Using for the first Time Prior Using for the first Time Prior Using for the first Time Prior Using for the first Time
Before using your dishwasher for the first time: Before using your dishwasher for the first time: Before using your dishwasher for the first time: Before using your dishwasher for the first time:
A. Filling salt into the salt container (water softener)
B. Fill the rinse aid dispenser
C. Fill in detergent