BOMANN GSP 7401, Instruction Manual

Page: 6 / 20

6
•
Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly (see “Adjust the
feet”).
•
Power cord and water hoses may not kinked or
squashed.
•
Avoid the installation:
Avoid the installation: Avoid the installation:
Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors),
as metal parts would be susceptible to corro-
sion under such circumstances;
-
in rooms where the temperature could drop
below freezing. Do not expose the appliance
any weather.
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.).
Removing the applian Removing the applian Removing the applian Removing the appliance cover ce cover ce cover ce cover
The appliance cover can be removed and thus re-
ducing the device height to 81.5 cm; to place the
dishwasher under a suitable kitchen worktop.
•
Loosen the screws on the unit back and remove
the cover.
•
After removing the cover, retighten the screws.
Installing sound
Installing sound Installing sound
Installing sound----absorbing strips (if required)
absorbing strips (if required) absorbing strips (if required)
absorbing strips (if required)
Top Left Right
If the appliance cover has not been removed, skip
the first step. Install the sound-absorbing strips left
and right only.
•
Remove the protection from the sound-absorbing
strip (top) and attach the strip to the upper appli-
ance frame.
•
Loosen the four screws on the right and left appli-
ance side.
•
Remove the protection of the sound-absorbing
strips (left + right), attach the strips to the appli-
ance sides; Pay attention to the correct alignment
with the pre-punched holes.
•
Screw in the four screws again.
Adjusting the feet Adjusting the feet Adjusting the feet Adjusting the feet
Check with a spirit level whether the
appliance is leveled horizontally. If
the unit is not in balance, the feet
must be adjusted.
Water connection
Water connection Water connection
Water connection
CAUTION:
CAUTION: CAUTION:
CAUTION:
•
The Installation of the water supply must conform
to the local laws and regulations.
•
The appliance is not not not not suitable for hot water supply.
•
Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
•
If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.