BOMANN GS 7343, Instruction Manual

Page: 28 / 32

28
WARNING:
During repair/maintenance work, the appliance must
NOT be connected to the mains power!
Replacing the door seal

Remove the contents of the appliance and, if
necessary, defrost the appliance. Pay attention to
how the old seal is fixed. Most gaskets are only
plugged in or fixed by small screws.

Remove the worn gasket rubber by either remov-
ing it from the plug-in device or loosening the
screws. Carefully clean the appliance door and
the groove below the rubber and remove any ad-
hesive residue.

Depending on how the old sealing rubber was
attached, attach the new rubber. If necessary,
heat the sealing rubber with a hair dryer or hot
water and shape it by hand. Start pressing the
gasket in one corner and then press it all around
the door into the provided socket.

According to the type of appliance, refasten the
screws or plug-in positions on the appliance.

Continue to check the door seal regularly for dirt
and damage!
Replacing the door handle

Loosen the screw cover caps.

Unscrew the screws.

Remove the door handle.

Door handle assembly is performed in reverse
order.
Replacing the door hinges

Remove the contents of the appliance and the
interior fittings.

Tilt the appliance back-
wards and block it in this
position to prevent the ap-
pliance doors from sliding
out.
Replacing the upper door hinge

Depending on the type of appliance, first loosen
and remove the appliance or hinge cover.

Disassemble the upper
door hinge by loosening
the screws.

Door hinge assembly is performed in reverse
order.
Replacing the middle door hinge

First disassemble the upper door hinge "Replac-
ing the upper door hinge".

Remove the upper appliance door and place the
door safely aside.

Disassemble the middle
door hinge by loosening
the screws.

Door hinge assembly is performed in reverse
order.
Replacing the lower door hinge

Depending on the appliance type, first unscrew
the stand foot.

Disassemble the lower
door hinge by loosening
the screws.