![background image](http://html1.mh-extra.com/html/bomann/776041/776041_instruction-manual_2785986020.webp)
20
CAUTION:
When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
When installing, ask another person to assist.
Wear protective gloves to prevent injuries from
any sharp edges.
Drilling dimensions
Unit
mm
[03]
[04]
[05]
Determine the position of the cooker hood central-
ly above the cooking area in accordance with the
specified safety distances.
Totally 9x mounting holes with a diameter of approx.
8 mm are necessary for the wall mounting. Insert the
supplied dowels [08].
Mark the holes required for wall mounting as
shown in the drawing. First specify the extension
length of the shaft cover for the position of the
bracket [04] at the upper shaft end. Check the
markings with a spirit level!
Fix the bracket [05] for the hood body with three
screws ST4x30mm [09] and the brackets [03] and
[04] at the pre-marked positions, each with two
screws ST4x30mm [09].
Before inserting the hood, affix the non-return
valves [07] by gently bending them from above
onto the exhaust duct.
For exhaust mode:
Hereupon a flexible exhaust hose
(included in delivery) with 150 mm inner diameter
must be attached.
Hang up the hood body onto the bracket [05].
Check the secure hold and the horizontal position
and tighten two screws ST4x30mm [09] through
the hood body.
For exhaust mode:
Check the correct position of the
exhaust hose and connect it with the outlet opening.
Put on the telescope shaft unit and secure the
lower shaft with the bracket [03].
Pull up the inner shaft and fix the shaft cover
sideways with the hood body and the bracket [04]
by screwing in each two screws ST3x10mm [10].