35
Wash temperature
Select the temperature corresponding to the textiles
and pollution. Basically: the higher the temperature,
the higher the power consumption.
90°C : Heavily soiled pure white cotton or linen (e.g.
tablecloths, sheets and towels).
40°C_60°C : Moderately soiled colored cotton, linen
and synthetic (e.g. shirts or underwear). Slightly
soiled whites (e.g. underwear).
cold_20°C_30°C : Normally soiled laundry (including
synthetic and wool).
Capacity
Do not overload the appliance otherwise the laundry
is not getting clean. Refer to the information in the
"Program table"
.
Starting the program
Connect the appliance to the power supply and
switch it on.
The water supply must be opened to the maxi-
mum pressure.
Load your laundry and fill in the detergent, if nec-
essary.
Close the appliance door properly.
Set the required washing conditions.
Start the operation.
Door lock
Once a wash program has been started, the appli-
ance door cannot be opened.
When the wash cycle is finished, the door lock will
automatically be unlocked.
Refill laundry
WARNUNG:
Never attempt to force open the appliance door dur-
ing operation.
After the program has started, you can refill or re-
move laundry as needed. Interrupt the washing pro-
cess with the Start/Pause- button. The appliance
checks whether a refilling is possible and, if neces-
sary, releases the door lock after a short time.
As soon as the water temperature or the water level
exceeds a certain value, the door remains locked for
safety reasons and cannot be refilled.
Changing the program
To change the program, first interrupt the washing
process.
Switch the device briefly off and then on again.
Select the desired program and start the new
operation.
End of program
At the end of the wash cycle the display appears
[End].
Several beeps sound (provided muting is de-
activated); a few minutes later, the door lock is re-
leased and the appliance enters off-mode.
Switching off
Switch off the appliance (turn the program selec-
tor switch to the Off-position).
Close the water supply!
Leave the appliance door slightly open until the
next wash cycle to avoid odors.
If the appliance is not in use for an extended peri-
od, disconnect the mains plug or switch off or turn
out the fuse.
Power consumption in off-mode 0.50 W / in standby-
mode N/A / with start delay 4.00 W.
Energy saving tips
If possible, avoid the selection of high wash tem-
peratures. Modern detergents achieve good
washing results even at low temperatures.
