background image

8. Alarm System Limitations

Even  the  most  advanced  alarm  systems  cannot  guarantee  100%  protection  against  burglary  or 

environmental problems. All alarm systems are subject to possible compromise or failure-to-warn for a 

variety of reasons.

Please note that you may encounter problems with your system if:

• The sensors are not placed within hearing range of persons sleeping or remote parts of the premises.

• The sensors are placed behind doors or other obstacles.

• Intruders gain access through unprotected points of entry (where sensors are not located).

• Intruders have the technical means of bypassing, jamming, or disconnecting all or part of the system.

• The power to the sensors is inadequate or disconnected.

• The sensors are not located in proper environmental/temperature conditions i.e. too close to a heat 

source.

Note: Inadequate maintenance is the most common cause of alarm failure; therefore, 

test your system at least once per week to be sure the sensors and sirens are 

working properly.

Although having an alarm system may make you eligible for reduced insurance 

premiums, the system is no substitute for insurance.

the setting is completed, please press the "DONE" button.

C. ARM Mode

•  Press  the  "ARM"  button  to  ARM  or  turn  off  the  sensors  under  this  mode.  Once  the  setting  is 

completed, please press the "DONE" button.

6. Maintenance 

The product may be cleaned with a soft damp cloth and then wiped dry. Do not use abrasive, solvent 

based or aerosol cleaners as this may damage and/or discolour the product. Do not allow water to 

enter or attempt to clean inside the unit.

7. Batteries

Do not allow the batteries to corrode or leak as this may cause permanent damage to the product. Take 

care to insert the batteries with the correct polarity as shown inside the battery compartments. Do not 

mix new and old batteries or different types of batteries. Do not use rechargeable batteries.

At the end of their useful life the batteries should be disposed of via a suitable recycling centre. Do not 

dispose of with your normal household waste. DO NOT BURN.

. 4 .

[email protected] . www.redshieldsecurity.com

Summary of Contents for WS-103S

Page 1: ...cessary IMPORTANT The Motion Sensor is immune to pets moving on the floor or climbing on furniture as long as the activity takes place below 1m 3ft Above the 1m 3ft height limit adjust the sensitivity of Motion Sensor to Middle or Low position so more movement is required to trigger the sensor but the pet immunity will decrease as the pets get closer the sensor It is important to perform a Walk Te...

Page 2: ...ition Detection range H 13m M 8m L 5m depends on the environment status When the sensitivity is set to Low more movement is required to trigger the sensor It is recommended to set the sensitivity to Low and perform a Walk Test Described in part 3 5 If the walk test result is satisfactory the sensitivity does not require further adjustment If the walk test result shows the sensitivity is too low th...

Page 3: ...creen together with the DING DONG sound Fig 4 Press ADD MORE button again if you want to add sensors or press DONE to complete the sensor enrollment Sensors can also be deleted on the ADD DELETE SENSORS screen Select the sensor name on panel and then press the DELETE button The sensor name will be disappeared and deleted Install the sensors to desired location for the home protection 5 Customize s...

Page 4: ... sensors and sirens are working properly Although having an alarm system may make you eligible for reduced insurance premiums the system is no substitute for insurance the setting is completed please press the DONE button C ARM Mode Press the ARM button to ARM or turn off the sensors under this mode Once the setting is completed please press the DONE button 6 Maintenance The product may be cleaned...

Reviews: