Using the VC-310C as a Wireless Manual Master
|
29
To exit slave mode, press and hold the Mode button until the flash control mode indicator appears on the LCD.
Use the right arrow to cycle through the flash control modes until the standard flash control indicator appears
on the LCD.
Important!
When using a single slave flash, set it to the same group and channel as the master.
When using multiple slave flash units, select the same group and channel for all units being used in a
particular light position. For example, if you are using three VC-310C units, you might want to set one as a
main light 1A, the second as a fill light 1B, and the third as a hair light 1C. With this setup, you have the option
of setting each group to a different output level via the master flash.
Using the VC-310C as a Wireless Manual Master
The VC-310C can be used as a manual master, allowing you to set the
output level individually for each of the three slave flash groups.
To use the VC-310C as a wireless manual master, follow these steps:
1. Press the Mode button repeatedly until the manual mode indicator
[M] appears in the upper left hand corner of the LCD.
M
B 1
C 1
GROUP
CH
CH1
/128+0 3
/128
/128
A 1