Fig. 9.17
Fig. 9.18
5
Kit “G”
Kit “D” pos.26
16
21
14
9.3.18) Position the fl ange pos.5 and the impeller kit “G” (Fig.9.17).
9.3.19) Fit the inlet unit and secure it with the screws pos.27.
9.3.20) Fit the spherical cap pos.16 on the output shaft pos.26 (kit “D”) paying attention to
the O ring pos.39.
9.3.21) Align the water outlet hole on the shaft pos.26 with the nozzle holder pin pos.21
which is on the cap pos.16 (Fig.9.18).
9.3.22) Put a few drops of Loctite 572 on the dowel pos.14, fi t it on the cap pos.16 and
tighten it temporarily.
9.3.23) Put a few drops of Loctite 222 on the part pos.15 which is on the shaft pos.26 (kit
“D”), fi t and tighten nut pos.18 on part pos.15. Defi nitively tighten the dowel pos.14.
9.3.24) Position the washer pos.20 and complete assemble as in paragraph 9.1.6 – 9.1.7.
(00M-SW060CF-00-EN)
SW 060-CF.09-MANUAL Rev.00
22