bolid S2000-K, User Manual

Page: 18 / 50

Orion ISS
www.bolid.com
18
REVIEWING SYSTEM EVENTS AND PROCESSING ALARMS
The Event Display mode and the Indicate Alarms mode (for the messages received from the network
controller) are optional and should be set specially while configuring the system (see the Section
Programming the S2000-K to Display Events and Indicate Alarms of this Manual). For such the
modes the LCD of the keypad displays defined for this keypad messages about the events of certain
type occurred in specified partitions of the Orion system such as arming and disarming zones and
partitions, alarms, faults, etc. (the full list of supported messages is given in the Appendix to this Man-
ual).
A message from the network controller is displayed on the keypad LCD for 15 seconds, being accom-
panied by turning on the LED indicator, and then the display switches into the Time Display mode. If
two or more messages are received simultaneously, the keypad displays them consistently during a
second each, the last message being displayed for 15 seconds. For forced exit into the Time Display
mode it is necessary to press CLEAR.
The last 255 received messages are stored in the S2000-К non-volatile memory. The buttons
t
and
u
are intended to browse the message log, with scrolling messages in direct chronological order be-
ing executed by the
t
button, and scrolling in reverse order being executed by the
u
button. To re-
view the time of message delivery press and hold the
0
0
0
button.
If the Display Events mode and the Indicate Alarms mode are set on (see the Programming the
S2000-K to Display Events and Indicate Alarms section of this manual), then receiving an alarm mes-
sage from the network controller causes the S2000-K keypad to turn its LED indicator on in blinking
mode, output the message on the display and turn on the beeper (except the PANIC ALARM mes-
sage). The type of a sound signal (the supported sound patterns are showed below) allows the opera-
tor to identify the alarm message type. The sound signal can be stopped by pressing any S2000-K
button.
INTRUSION ALARM
FIRE PREALARM
FIRE ALARM
TAMPER ALARM
LOOP DISCONNECTED
DEVICE RESET
COMMUNICATIONS LOST
LOOP SHORT FAILURE
LOOP OPEN FAILURE
POWER FAILED
t
t
t
t
t