6
How to Use the Efir-K for Arming/Disarming
The Efir-K Set can be used as a part of burglary alarm system for remote arming and disarming of
protected premises being co-operated with any control and indicating equipment.
Let us consider the Efir-K Set integrating into the security system based on BOLID Company
manufactured control and indicating equipment such as SIGNAL-VKA, SIGNAL-VK2, SIGNAL-VK-4P,
SIGNAL-VK4 iss.05 and SIGNAL-VK6. To use the Efir-K in such a manner:
1. Program the Receiver to be of operating mode #1 as explained before.
2. Program the needful number of Keyfobs to be in use.
3. Attach the Receiver at a suitable location where all programmed Keyfobs are operating. Do not place
the Receiver behind metal blinds, near large metal objects, power lines, air conditioners and sources
of the electromagnetic, thermal and RF fields.
4. Wire the Receiver to your SIGNAL equipment according with the scheme in Figure 4 and directions
from Table 1.
Such a system operates as follows.
Being coming out of premises an owner closes the door and presses on the large Keyfob button. An
encoded control signal is sent out at once. The signal is detected and decoded by Receiver. In case of
authorization having been successful, the Receiver relay is switched on forcing the SIGNAL device for
arming. The Receiver LED shall light by red.
In order to go inside the premises an owner presses on the small Keyfob button. If the owner stands
within Receiver reach then the Receiver returns the relay to its initial state and the LED goes down. The
SIGNAL device stops monitoring for protecting zones enabling entering inside object without any alarm.
Connecting of an Efir-K Receiver to a SIGNAL control and indicating equipment is specified in Table
1
.
Figure 4: Using the Efir-K for Arming and Disarming
…………
Keyfob 1
Keyfob 2
Keyfob 15
Receiver
12 VDC OUT
Burglary
Zone
to COM
to NC
SIGNAL
