N2400340 Rev. 2
Page 5
compensate for changes in sample height. The Boekel UV Crosslinker
may be used in either Time Mode, in which the unit runs for a user-
defined amount of time, or Energy Mode, in which the unit runs until a
user-defined amount of energy has been accumulated.
This unit comes equipped and calibrated with a quantity of (5) 254 nm
Shortwave bulbs. Should the need arise for use of a different UV
wavelength, the bulbs can be swapped for bulbs of a different
wavelength and the new wavelength can be easily selected in the
Boekel UV Crosslinker Setup menu. The Boekel UV Crosslinker
automatically applies calibration settings for the new bulb wavelength,
maintaining accurate readings for sensed UV energy in both Energy
Mode and Time Mode. There is no need for the user to manually
recalibrate the unit when changing bulbs.
3.0
Assembly
Remove the packing materials carefully and retain for future shipment
or storage of the unit. Inspect for damage. Report all shipping
damage to the carrier immediately. Shipping damage is covered by
the carrier and repair/replacement for shipping damages must be
coordinated through the carrier. Complete and return the Warranty
Registration Card. Each package should contain:
1 UV Crosslinker
1 Power Cord
5 each 254 nm Shortwave Bulbs
Operating Instructions
Warranty Card
4.0
Identification of Controls -
See Figure 1 and 2 on Page 6
1.
LCD Display
2.
Power Key – used to toggle power to unit
3.
Mode Key – used to toggle between Time mode and Energy
mode
4.
Reset Key – used to reset parameters after completion of a cycle
5.
Start/Stop Key – used to start and stop cycles
6.
Up/Down Arrow Keys – used to increase or decrease parameters
7.
AC Power Socket – connection point for power cord
8.
Height Adjustment Knob – used to adjust the height of the bulbs
relative to the chamber floor
