Bodyworx JX735, Manual

Page: 13 / 25

13
II. Operation Mode：
1.
Under start/ready status, press “Mode” to enter
edit mode
.
2.
Under start/ready status, press
Start
to enter directly by “Manu run”.
3.
When the SAFETY KEY is taken off and then replaced, it will not make reposition action
any where it is. You need to press start key to perform the incline to reposite it.
4. When power on, it will not make reposition action any where it is. You need to press start
key to perform the incline to reposite it.
5. Under start/ready status, continuously press stop key for 5 seconds, it will make
reposition action any where it is.
During perform any program, if press stop key, the program will stop. If users want to
continuously perform the program, press start key or again press stop key to leave the
program and back to start/ready status.
III. Edit Mode：
1.
Under Start/Ready position, press
Mode
to choose Manual and Program mode by press +/-
key.
2.
Program
mode：Press +, - keys to edit
Program
（
P1~P8
）. The light
PROGRAM
indicates blinks. LCD can display P1~P8
for users to edit. Press +, - to edit. Press
ENTER to enter TIME edit. The preset value is 30min
，
range is 20~99 min
，
STEP
is
1 min.
After edit, press ENTER or START to start the machine. If you press START directly
during edit, the rest un-edited functions are pre-set. During edit, INCLINE and SPEED
window will display first level value. The matrix window will display this picture.
3. WARM UP and COOL DOWN function: During WARM UP or Program position, change
speed or inclination, the value will increase or decrease in the next level. COOL DOWN is
not affected and STOP is the only function which can be carried out.
4. PROGRAM has 30 levels in all. The three anterior are WARM UP, the three later are
COOL DOWN. Everyone is 3 minutes. The setting time except anterior and later which
mean 6 minutes will be execute averagely by surplus 24 levels.
5. 9 HOLES mode have not functions of WARM UP or COOL DOWN. When distance is
equal to 3.5KM, the motor will stop, the INCLINE is 0 and displays ” End”.
IV.
Program Operation and Instruction：
Manu mode
1.
When press Start
,
it will begin to count down for 3 seconds, after that, the motor will start ,
the speed will start at 0.8KPH
（
0.5MPH
）
. The matrix window goes contrarotate like along
playground, every circle is 0.4KM (0.25MIL).
2.
Speed STEP is 0.1, you can press +, - keys to select
（
the speed UP/DOWN step is 0.1
）
, or
press speed instant key 1
、
2
、
4
、
6
、
8
、
10 to select .
3.
Incline STEP is 1, you can press +, - keys to select
（
incline UP/DOWN step is 1
）
, or press
incline instant key 2
、
4
、
6
、
8
、
10
、
12 to select.
4.
TIME set or not set: