7. MAINTENANCE
1.
If the belt tends to move off from the center,
stop the treadmill. Take the Hex Wrench and
adjust the Hex Screw in the Rear Roller. For
example, if the running belt is moving towards
the left side, tighten the left Hex Screw about
1/4 turn (clockwise). Do the same to the right
side. If the running belt is moving towards the
right side, tighten the right Hex Screw about
1/4 turn (clockwise). Turn on the treadmill
after it has been adjusted. If you find that the
belt has not moved to the proper position, just
repeat the steps above. Don’t use the treadmill
until the running belt returns to the center
position.
(Ps.1. This action is very important, if the belt
is not in the center, be sure to follow the
above steps.)
(Ps.2 The position of running belt might not
stay precisely in the center with slightly towards
the left or right side, and the situation varies with
how end-users use and the weight of end-users.
It’s need to adjust the belt if it doesn’t rub against
the parts aside.)
2 Depending on the frequency the product is used,
it is advisable to apply SILICON on the board
according to the below chart. First Hex Wrench is
used to unscrew the bolt inside the Rear Roller.
Then pull the belt up and daub some SILICON to
the center of the board. After that, adjust the belt to
the center of the deck, followed by tightening the
screw to the original set.
(Ps. When the belt is sliding, please follow the
above method to lubricate the running belt.)
KGS/LBS
Speed
Interval
6KM/hr below
1 year
6~12KM/hr
6 months
KGS
12KM/hr above
3 months
4mile/hr below
1 year
4~8mile/hr
6 months
LBS
8mile/hr above
3 months
