8
3. Handlebar Post, Handlebar Post Cover, and Tension Control Knob Installation
Remove four M8x15 Bolts (57), four
Ø
20x
Ø
8x2.0 Washers (12) from the Main Frame (27).
Remove bolts with the S6 Allen Wrench provided.
Slide the Handlebar Post Cover (55) up to the Handlebar Post (59).
Insert the Tension Cable (26) through into the bottom hole of Handlebar Post (59) and pull it
out from the square hole of Handlebar Post (59).
Connect the Sensor Wire (28) from the Main Frame (27) to the Extension Sensor Wire (56)
from the Handlebar Post (59).
Insert the Handlebar Post (59) onto the tube of the Main Frame (27) and secure with four
M8x15 Bolts (57), four
Ø
20x
Ø
8x2.0 Washers (12) that were removed. Tighten bolts with
the S6 Allen Wrench provided.
Slide the Handlebar Post Cover (55) down to the Handlebar Post (59).
Remove the
M5x55 Bolt (62)
and
Ø
5x
Ø
15 x1.0 Big Washer (61)
from the Tension Control
Knob (58). Remove bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (54) into the spring hook of
Tension Cable (26) as shown in drawing A of figure 3. Pull the resistance cable of Tension
Control Knob (58) up and force it into the gap of metal bracket of Tension Cable (26) as
shown in drawing B of figure 3. Attach the Tension Control Knob (58) onto the Handlebar
Post (59) with the
M5x55 Bolt (62)
and
Ø
5x
Ø
15 x1.0 Big Washer (61)
that were removed.
Tighten bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Summary of Contents for MAGNECTIC BIKE
Page 3: ...2 OVERVIEW DRAWING...
