28
87
75
45
75
97
23
4
97
16
88
99
99
99
23
55
88
44
17
93
23
45
75
45
75
45
12
11
33
42
92
41
28
1
7
95
95
101
102
101
104
102
104
101
101
107
107
101
101
107
102
102
95
95
102
102
75
77
76
75
19
45
45
S
TEP 3 ASSEMBLE SEAT FRAME AND SEAT BACK
7
1. Attach Seat Frame(11) to Front Upright(4) using two 3/8"X3" Bolts(88) four 3/8" Washers(101) and two
Nuts(107). Attach Seat Frame(11) to Base Frame(1) using one 3/8"X4-1/2" Bolt(87), two 3/8" Washers
(101) and one Nut(107).
2. Attach Leg Extension Arm(12) to Seat Frame(11) by aligning holes and then inserting Leg Extension
Axle(33). Fasten Leg Extension Axle(33) using two 5/16" Spring Washers(104), 5/16" Washers(102), and
two 5/16"X5/8" Set Screws(97). Check to ensure that the Leg Extension Arm(12) pivots freely.
Note: The L Pin(55) is used to lock the Leg Extension Arm(12) into place when using the low
cable for exercises such as arm curls, leg kicks, upright rows, etc. Remove the L Pin when
performing leg extensions and leg curls.
3. Insert Foam Roller(23) into hole in Seat Adjuster(16) and into hole in Leg Extension Arm(12). Moisten
Foam Pad(75) with water and slide onto each end of Foam Rollers(23). Attach 1" large Round Plug
(45) to Foam Roller(23). A rubber mallet is useful. Lock into place with pre-installed set screw.
4. Attach Seat Pad(77) to Seat Adjuster(16) using two 3/8" Washers(101), and two 3/8"X1-3/4" Bolts(92).
Attach 25mmX50 Plug(44) to Seat Adjuster and 50mm SQ. Plug(40) to Seat Frame(11). Insert Chromed
Seat Adjuster(16) into Seat Frame(11) and lock into place with Pop Pin(53).
5. Attach Seat Back Adjuster(17) to Front Upright(4), using one 3/8"X3" Bolt(88) and 3/8" Nut(107). It may
be necessary to tighten this bolt, then lossen just enough to let Seat Back Adjuster pivot freely.
Attach Pop Pin(53) for Seat Back Adjuster to Front Upright(4). Attach two Metal Hinges(19) to top of
Seat Back Adjuster(17), then attach Back Pad(76) to Metal Hinges(19) using two 3/8"X1-3/4" Bolts(93)
and 3/8" Washers(101). Insert Foam Roller(23) into hole in Seat Back Adjuster(17). Moisten two Foam
Pads(75) with water and slide onto each end of Foam Roller, then cap Foam Roller(23) with 1" large
Round Plug(45). Lock into place with pre-installed set screw.
6. Attach Weight Shroud(28) to Base Frame(1) and Top Guide Rod Retainer(7) using four 5/16"X1/2" Bolts
(95) and Washers(102).
