3
Step2
.
Six Fixing Bolt (M8X16 ) (6 ) lock lower support
(7 ) with the underbed
Step1
.
Decorate cover (5 ) it while entering lower
support (7 ), pay attention to not blocking in
the square hole
Step3
.
Put Decorate cover (5 ) in the square hole that
the card enters lower support (7 ) (shifts down
Decorate cover (5 ), should pay attention to the
direction), regular and easy to decorate cover.
Step5
.
Lock Adjustable spring Knob (pt.8) into the side
nut of Lower support (pt.7) approximately 1/3
and then, at the same time, pull back the
Adjustable spring Knob (8). Put down Upper
support (pt. 10) to Lower support (pt. 7) and
release the Adjustable spring Knob (8). Slide
Upper support (pt. 10) down until it meets
Adjustable spring Knob (pt.8). Lock the hole of
Upper support (pt. 10) tight
Step4
.
Attach the upper support ( 12 ) to the
Motor (11) and fix with two M8X16mm
Fixing Bolts
( 6 ), and two washers (12)
ASSEMBLY INSTRUCTIONS
