A s s e m b l y S t e p 6
Hardware Required
PULSE HANDLE BAR ASSEMBLY
Install the
Pulse Handle Bar (#05)
onto the front side
of the
Center Post (#02)
as shown in the illustration
below using two
Bolts (#19)
and two
Washers (#29).
Please ensure the
Hand Pulse Wire (#13)
is free and
clear, avoiding pinching it during this assembly step.
You will need to connect this wire to the
Monitor (#46)
later.
Attach the
Clamp Cover (#24)
onto the
Pulse Handle Bar
(#05)
as illustrated.
COMPUTER ASSEMBLY
Remove the four
Screws (#25)
that are pre-assembled
on the
Monitor (#46)
. Set them aside nearby as they
will be used later in this process.
With the help of an assistant, connect the
Main Sensor
Wire (Middle) (#11)
to the corresponding wire on the
Monitor (#46)
(diagram A). Connect the end of
Hand
Pulse Wire (#13)
the back hole as illustrated below (diagram B).
to the
Monitor (#46)
by inserting it into
Being careful not to pinch/damage any of the wires, tuck in
the connected wires through the mouth of
Center Post
(#02)
and attach the
Monitor (#46)
to the bracket on the
Center Post (#02)
by using the four
Screws (#25)
that
were previously removed.
A
B
Page 11
WASHERS
BOLTS
#19. Bolt (M8x30 mm)
[2 Pieces]
#25. Screw (M5x10 mm)
[4 Pieces]
#29. Spring Washer (M8)
[2 Pieces]
Assembly Instructions
BR1895/2895