Assembly Instructions
A s s e m b l y S t e p 5
H a r d w a r e R e q u i r e d
Bolt
#30. Screw (M5x12 mm)
[4 pieces]
BRB 5288
After complete assembly: If the computer
is
not picking up your hand pulse signal
(or you are getting inaccurate readings),
Please refer to our “Troubleshooting”
section on
Page 13
for other troubleshoot
issues.
HAND PULSE SIGNAL
Page 9
Computer Assembly
Remove the four
Screws (#30)
that are pre-assembled on the
Monitor (#43)
and set them aside nearby.
Attach
Monitor (#43)
to
Sensor Wire for Front Post (#41)
.
Then, attach the
Monitor (#43)
to the bracket of
Front Post
(#04)
using four
Screws (#30)
that were set aside earlier.
Connect
Handle Pulse (#42)
into the power plug hole on the
back of
Monitor (#43)
as illustrated in exploded diagram.
The assembly process is now complete. However, for your own
safety, please make sure to read this entire Owner’s Manual which
includes safety instructions and warnings, as well as any safety
/warning labels affixed to the product before use.
For your safety, please visually and functionally inspect and test
the unit after assembly is complete.
Note:
This Magnetic Recumbent Bike is intended
to be correctly orientated in a vertical or floor
mount position.
Please ensure wires are protruding out of. If not, you
may have to use a bent wire to “fish” them out.
Troubleshooting
