A s s e m b l y S t e p 3
Page 7
H a r d w a r e R e q u i r e d
Bolt
#37. Nut (M8)
[2 pieces]
#25. Screw (M8x65 mm)
[2 pieces]
Washer
#28. Screw (M8x15mm)
[3 pieces]
#35. Arc Washer (M8)
[7 pieces]
#33. Spring Washer (M8)
[3 pieces]
Nut
BRB 5288
A.) Sensor Wire Connection & Tube Assembly
Remove the pre-assembled parts from
Front Post (#04)
and set
them aside nearby: Three
Screws (#28)
, three
Spring Washers
(#33)
, and three
Arc Washers (#35)
.
With the help of an assistant, connect
Tension Control (#38)
to
Tension Control Cable (#39)
as shown in exploded diagram A,
and
Sensor Wire for Front Post (#41)
to
Sensor Wire for Main
Frame (#40)
as shown in the exploded diagram B.
Then, being careful to tuck the connected wires into the hollow
tubing to avoid pinching/damaging the wires, slide
Front Post (#04)
onto the protruding tube of
Main Frame (#01)
. Secure using a total
of three
Screws (#28)
, three
Spring Washers (#33)
, and three
Arc
Washers (#35)
that were set side nearby.
B.) Front Handle Bar Assembly
Attach the
Front Handle Bar (#05)
to the front of the
Front Post
(#04)
by inserting two
Screws (#25)
through two
Arc Washers
(#35)
up through the
Front Post (#04)
and secure together using
two Arc
Washers (#35)
and two
Nuts (#37)
.
A
B
Assembly Instructions
TENSION WIRE ASSEMBLY
Insert the tip of the
Tension
Control (38)
wire into the
Tension
Control Cable (39)
head at an angle.
Tilt the
Tension control (38)
wire
into the crevice and then pull upward.
