1) Remove both service hatches by loosening
the locks with a coin, see figure 17.
2) Release tension completely on the brake.
3) Remove the two screws holding the brake
block to the frame by using an 8 mm wrench,
see figure 18
4) Take the new brake block and fasten it to
the frame by tightening the screw closest to
the brake block. Then place the block in the
correct position under the brake (see figure
19).
5) Fasten the remaining screw furthest
away from the block, and then make sure
that both screws are tightened properly, see
figure 20.
6) Grease should be applied to the cavity
on top of the brake block or to the top nut
on the brake to ensure a smooth interaction
between the two.
7) Remount both service hatches.
Figure 18
Figure 19
Figure 20
Remove
screws
Install and
twist
Reinstall the
last screw
REPLACING THE BRAKE BLOCK
018
