Bodum Bistro 11303, Instructions For Use Manual

Page: 10 / 132

9
BISTRO
firmly. Place the lid cap (1) into the opening in the lid.
Turn on the main power switch (10) on the back of the
housing. The indication light lights up. The START-button (7)
blinks to indicate the blender is now in the standby-mode.
– Select a speed by turning the speed control (5).
– Press the START - button (7) to start the motor. The
START - button remains lit up continuosly while the appliance
is in operation.
– In , or speeds, you can remove the lid cap (1) care-
fully to add liquids or ice cubes. Make sure the content
cannot spill out before you remove the lid cap. When
operating with full pitcher or hot liquids at high speeds
( , ), stop the blender before removing the lid cap to
add ingredients. If blending hot foods or liquids, remove
the lid cap and operate only on speed.
– Press the STOP-button (8) to stop.
– If you prefer to use the pulse-mode for mixing, set the
speed and press the PULSE-button (6) and keep on press-
ing until you are finished mixing. The PULSE-button
remains lit up while the appliance is in operation.
– Stop and check the consistency of foods after some
seconds and use a spatula to redistribute it.
– Make sure the main power switch is switched off before
removing the lid.
WHEN YOU HAVE FINISHED MIXING, SWITCH OFF THE
APPLIANCE AND DISCONNECT THE BLENDER FROM THE
MAINS.
– Remove the jar from the motor base (4) to serve. Place
the lid on the blender jar in a manner that the content
can be poured out through the strainer (B: STRAIN( )
should align with spout) or the opening of the lid
(C: OPEN ( ) should align with spout). Keep the lid cap
on the lid.
ALWAYS MAKE SURE NO BUTTONS ARE LIT UP AND THE
APPLIANCE IS SWITCHED OFF BEFORE REMOVING THE
LID FROM THE BLENDER JAR. ALWAYS MAKE SURE THE
APPLIANCE IS DISCONNECTED FROM THE MAINS BEFORE
REMOVING THE JAR FROM THE MOTOR BASE.