BODECKER BREWED BREWER, Manual

Page: 22 / 72

2007 Bodecker Brewed. All Rights Reserved. 22
MOST PROBLEMS CAN BE RESOLVED BY SHUTTING OFF THE POWER AND TURNING
BACK ON. TURN OFF THE POWER BEFORE PROCEEDING WITH ANY TROUBLE-
SHOOTING ACTIVITY
1. Review shuttle staying in position
2. Possible spring out
3. Facial plate not in place
4. Corner of facial plate loose
5. Guillotine too low, preventing shuttle from sliding in
6. Pull coffee outlet to ensure it’s free
7. Place bob-cup in shuttle; observe green ready light on. If it goes off, review steps 1-3 and check limit
setting for cup switch.
8. Review service LED panel.
9. To check shuttle operation, place a screwdriver between bearing and shuttle to see if it slides in and
out easily.
10. Enter service mode with shuttle out by scrolling down to SERVICE. Now press SHORT. The current
temperature will appear. Now press TALL. IU will appear. By pressing the REGULAR button the
guillotine will start to operate. To get out of the program press HOT WATER button, then REGULAR
button. This will engage the guillotine. To ensure it is functioning properly allow it to return to HOME.
Install shuttle repeat process. If it jams, the pitchforks are hitting either the side rails or the bearing,
OR the shuttle is jammed with hot chocolate. Remove the guillotine and move up and down by hand
to observe the problem. Adjust pitchforks or shuttle stop accordingly.
11. Roller bearing on guillotine should always be in its resting position: 1/32 of an inch to the right of
center on the injector pin in the upper position. The roller bearing should be within 1/32 of an inch of
the center. If either is out, reset limits. If shuttle does not go in all the way the guillotine is too low OR
the horseshoe needs adjusting. Observe shuttle wear spots for possible clues.
12. Notes: TALL to service, then SHORT, current temperature, then TALL, then REGULAR. IU will give
motor action.