Bodart & Gonay Optifire OPTI700, Instructions For Use And Maintenance Manual

Page: 6 / 40

6 Opti-
OK!
1
3
2
15. The variator: It enables adjustment of fan
speed.
1. Speed adjustment.
2. Minimum speed adjustment screw under the
knob
3. Fuse (Remove the knob, unscrew the plate,
remove old fuse, replace with identical fuse).
1.2. Opening – closing the door
1.3. Fire behaviour
Quality wood is:
- Dry wood that has been drying for at least 2 years in a ventilated
sheltered area.
- Use logs from broad-leaved trees in preference to those from coni-
fers, which tend to burn quickly and produce lots of soot. In order of
preference: hornbeam, oak, beech...
- It is also possible to use logs of compressed wood shavings and bri-
quettes.
An excessive load of wood leads to:
- A reduction in yield and an increase in
wood consumption.
- A signifi cant loss of heat through the chimney.
- Premature ageing of the fi replace and chimney fl ue.
During the fi re, open the door slowly. Opening it suddenly causes a
temporary backdraft in the fi replace.
To close the door: lift the handle, press the door against the heating
unit so that the seal is gently compressed, then lower the handle until
it is locked.
It is normal for the fan to cut out when opening the door.
The quality and the drying of the wood are of prime
importance for the fi replace to operate at its best
(heater power and yield, cleanliness of glass).
Do not forget to calibrate the variator; refer to the
installation manual in options 6.