BOC E2M28, Instruction Manual

Page: 12 / 52

E2M28 and E2M30 Rotary Vacuum Pumps
TECHNIC
A
L
D
A
TA
PAGE
6
Issue K 6 Jul 05
2.3 Mechanical data
2.4 Lubrication data
Note: A BOC Edwards Material Safety Data Sheet for the oil specified below is available on request.
2.5 Electrical data
Refer to Tables 5 and 6. The motor start-up current is drawn for less than one second, so you must use
slow-blow fuses to prevent unnecessary fuse failure when the pump starts. Fuses should be to EN60269
Section 2.2. For conformance with CSA standards only CSA certified fuses are to be used. If you use the
pump at temperatures lower than 13 ºC, the start-up current will be drawn for longer; this may cause
the motor thermal overload device to open.
Approximate pump mass 44 kg
Dimensions See Figure 2
Degree of protection
Single-phase motors
Three-phase motors IP44
IP54
Pump inlet port
NW25 (the flange can be removed from the 1 inch BSP
threaded hole)
Pump outlet port 15 mm external diameter nozzle (the nozzle can be
removed from the
3
/
4
inch BSP threaded hole)
Table 3 – Mechanical data
Recommended oil * Ultragrade 19
Maximum oil capacity 1.32 litres
* To operate the pump when the ambient temperature is outside the range specified in Section 2.1, or
to optimise pump performance when you process condensible vapours, you may need a different oil.
Table 4 – Lubrication data