25
Limit Switches
Parts for the motion stepper motors:
A.
1 Frame assembly
B.
2 Limit switches (long wires)
C.
1 Limit switch (short wire)
D.
4 M2.5 x16 machine screws
E.
4 M2.5 nuts
F.
1 small nylon tie
1. Insert the small nylon tie through the Y limit switch ( long wires) hole, loop around
the rod and back up through the second limit switch hole. (Left side)
2. Tighten the nylon tie and cut off the excess.
3. Place the Z Limit switch (long wires) on the left frame near the top with 2 M2.5 x16
screws and nuts.
5. Tighten the nuts.
Summary of Contents for RP9
Page 1: ...RP9 Assembly Instructions ...
