11
12. Slide both 8mm rods through the bearings on the extruder assembly.
13. Slide both rods into the left and right assemblies with the extruder nozzle facing
down. The large slots in the extruder, bearing and large stepper motor hole are on the
same side as shown.
Note that the nylon tie under the Y limit (see page
25
) switch slots will be
installed differently.
14. For 7 of the nylon ties, wrap the rods by inserting large nylon ties through the side
opposite of the rods into the slotted holes of the left and right mounts.
Note orientation
Note orientation
Summary of Contents for RP9
Page 1: ...RP9 Assembly Instructions ...
