carry a complete set of spare
bulbs if possible.
The bulb is pressurised
and can cause injury if
damaged.
Wear protective goggles
and gloves when changing
bulbs.
The types of bulb fitted
to your motorcycle are
listed in the section entitled
"Technical data".
Do not touch the glass
of new bulbs with your
fingers. Use a clean, dry cloth
to hold the bulbs when hand-
ling them. Dirt deposits, in
particular oil and grease, in-
terfere with heat radiation
from the bulb. This leads to
overheating and shortens the
bulb's operating life.
Removing headlight
Ignition is switched OFF
While holding the headlight,
remove three screws
1
.
Remove cover panel
2
.
Disconnect plugs
3
,
4
and
5
.
Replacing low-beam and
high-beam headlight
bulb
Make sure the ground is
level and firm and place the
motorcycle on its stand.
Removing headlight (
85)
7
85
z
Maintenance
Summary of Contents for HP2 ENDURO
