BMS F-16C/D 4.34, Flight Manual

Page: 74 / 234

T.O. BMS1F-16CM-1 BMS 4.34 Change 2.00
BMS 4.34 Dash 1
© Red Dog 2012-2019
Page: 74
1.3.16. LIST page
The LIST page is used to access additional subpages. Each page can be accessed by pressing the
relevant ICP button: 1 for DEST, 2 for BNGO, etc. Please note: RCL, ENTR and M-SEL 0 buttons are
also used to enter INTG, DLINK and MISC subpages respectively.
Once again note the 4 and double arrows in the top right
corner, allowing the pilot to change the current steerpoint
without exiting the LIST page. It is not the case on the picture
but if VIP or VRP are mode selected they will appear
highlighted in the LIST page.
1.3.16.1 DEST page (1)
The DESTination page looks similar to the STPT page. The
main difference is that you can change any steerpoint
coordinates without direct effect on the HSD. When you
change a steerpoint with the STPT page the effects are
immediate since that particular steerpoint is active. Not so the
DEST page, which is quite handy for making steerpoints more
precise or simply for adding new steerpoints.
Please note: as with the STPT page any entered coordinate must start with the cardinal ICP key N(2),
E(6), W(4) or S(8). The scratchpad will not respond until the cardinal key is pressed.
Depressing DCS to SEQ with any steerpoint selected enters the Offset Aimpoint 1 & 2 subpages. This
lets the pilot set up two offset aimpoints for each INS steerpoint. Since BMS 4.33 you can change from
FT to KM or NM on the RNG line. DCS up until you see *FT*
(scratchpad asterisks around FT) then press any number key
to rotate through FT to KM to NM.
More information about offset aimpoints can be found in the
TO-BMS1F-16CM-34-1-1 manual
.
1.3.16.2 BNGO page (2)
The BINGO page is where you input your briefed Joker/Bingo
settings. It is made up of two lines: the first one is where you
enter your Joker or Bingo setting and the second line is the
total fuel remaining on board. If the FUEL QTY knob is in
NORM the VMS will call
“BINGO” upon reaching the value
set in the first line. It is good practice as a mission begins to
input the Joker value. You can then reset it to the briefed Bingo value once Joker fuel is reached.
Note the arrows next to the active steerpoint allowing you to change it as usual with the NEXT/PREV
button of the ICP.
1.3.16.3 VIP page (3)
This page is used to enter VIP settings. VIP can be calculated
manually but it is advisable to enter data given by a tool like
WDP. This data is DTC loadable and WDP can set your DTC
automatically as well. Nevertheless, should you need to input
the data manually it is possible using this page. The VIP page
must be mode-selected with the 0 (M-SEL) button for the VIP
symbology to be visible in the HUD (the text between the asterisks is then highlighted). Moving the
DCS to the right (SEQ) will enter the VIP-to-PUP page. Since BMS 4.33 you can change between FT,
KM & NM on the RNG line by moving DCS up until you see *FT* and then pressing any key as shown
above.