Operation
EASY- CHECK FN
Manual
Rev:00
9 / 10
Radio-Control
With the Transmitter / Receiver and the Software STAT-6 the data and statistics can be
sent to the computer by RADIO without any cable connection.
Data Printer Mega-Print
Print out all the data and statistics.
Line-Charger with 1.2V rechargeable Mignon battery
Data Printer Mega-Print
Technical Data:
Type of Printer
: Thermo printer
Characters/Line :
20
Data Transfer Rate
: 1200 baud
Printing Velocity
: max. 20 lines/sec.
Interface :
serial
Paper
: Thermo paper
57 mm wide, max. 10 m long
Power Supply
: Rechargeable NiCad battery
(approx. 60 hours operation/charge)
Size
: 110 x 80 x 45 mm
Weight
: approx. 240 g
Charging Unit
: 230 V/50 Hz / 6.0 V – 0.5 A
Charging the built-in NiCad Battery
Before using MEGA-PRINT for the first time the built-in NiCad battery must be
charged.
The built-in NiCad battery is charged with the charging unit supplied with the printer. The
cable of the charging unit is connected at the right-hand socket of MEGA-PRINT.
The charging time should be at least 4 hours.
Operating Instructions
1. The operation of MEGA-PRINT together with the Coating Thickness Meter EASY-
CHECK FN is explained in the operating instructions of EASY-CHECK FN
(Page 5).
2. When the printer MEGA-PRINT is connected to the Coating Thickness Meter EASY-
CHECK FN, MEGA-PRINT switches on automatically (the green LED flashes every 2
sec). When switching off EASY-CHECK FN, the printer is switched off automatically (the
green LED remains switched off).
3. The manual paper feed is performed with the key „Paperfeed“. When the printout is fin-
ished the paper stripe is transported out of the casing by pressing this key and can be
neatly turned off.
4. Faulty print out
Incorrect printed lines mean that the printer should be recharged.
