![background image](http://html.mh-extra.com/html/bmpro/trailcheck/trailcheck_owners-manual_2779812006.webp)
TrailSafe / TrailSafe
+
in calibration
1.
Wait until LED goes solid
PURPLE
.
2.
If occurring after removing pull-pin, wait until
indicator changes then put pull-pin back in.
Completed 1st or 2nd
calibration stage
If pin is in when Solid
PURPLE
, remove pin; if pin
is out when Solid
PURPLE
, put pin back in.
Pull-pin removed before
calibration stage completed
Put pull pin back in to restart.
House battery capacity sufficient for 15mins of emergency braking operation
TrailSafe / TrailSafe
+
or
TrailCheck standby or no power
If necessary, check TrailSafe / Tr
by depressing brake. Check if TrailCheck
connected to power source.
House battery may have
insufficient capacity for 15mins
emergency braking operation
Check battery to ensure at least 10Ah house
battery capacity available.
TrailSafe / TrailSafe
+
in
standby and battery may have
insufficient capacity for 15mins
emergency braking operation
Check battery to ensure over 10Ah house
battery capacity available.
TrailSafe / TrailSafe
+
breakaway
switch leaky or corroded
Do not use unit. Replace unit.
Pin out or trailer breakaway
CONDITION
STATUS
SOLUTION
TRAILCHECK STATUS INDICATOR
Correct operation of TrailSafe and SwayControl should be checked prior to each
use of the trailer. This check should be done prior to the trailer being hitched to the
towing vehicle. TrailSafe can be checked by depressing brake or pulling out the
safety pin. This will activate the system and illuminate the Status Indicator on the
side of the unit according to the table below:
1
X
FLASH ONCE
SOLID COLOUR
CONTINUOUS FLASH
NO LIGHT
KEY
LED STATUS
LED STATUS INDICATORS
6
Summary of Contents for TrailCheck
Page 1: ...TEAMBMPRO COM OWNER S MANUAL TrailCheck ...
Page 11: ...11 ...