Apply the hook Velcro to the TrailCheck on the side to be attached to the vehicle by
peeling off the clear tape.
Similarly attach the loop side Velcro to the vehicle where it will be mounted so that
the tapes will align.
Ideally clean the surface with isopropyl (rubbing) alcohol and leave for 24 hours
to achieve maximum adhesion before mounting the TrailCheck.
Avoid contacting the tape with fingers.
After completing installation of the TrailCheck, conduct a trial operation to check
for faults.
Test with the engine running. If there is too much metal between the TrailSafe series
or SwayControl and TrailCheck or a high level of electrical noise in the vehicle,
TrailCheck may not provide an adequate connection.
PAIRING THE TRAILCHECK TO THE TRAILSAFE SERIES.
To pair the TrailSafe series to the TrailCheck and enable system monitoring from the
TrailCheck, perform the following:
1.
Complete wiring of the TrailSafe System and confirm that the battery indication is
working when the Pull Pin is removed.
2.
Insert the Pull Pin
3.
Power the TrailCheck by inserting the power connection into the vehicles 12VDC
accessory socket and turn on the ignition.
4.
Press the button on the rear of the TrailCheck for 1 second confirming the Status
Indication is flashing
BLUE
5.
Operate the brake pedal and watch the TrailCheck Status indicator for up to 2
minutes.
a.
If the TrailCheck Status indicator turns solid
BLUE
for 2 seconds then pairing to
the TrailSafe was successfully. The TrailCheck Status indicator will then show
either solid
GREEN
, solid
ORANGE
or solid
RED
. See the TrailCheck Status
indicator output descriptions.
b.
If the TrailCheck Status indicator changes to flashing
ORANGE
then pairing
failed. Return to step 4 to try again.
If pairing does not work try an alternate location for the TrailCheck. Pairing can be
cleared by pressing and holding the button on the rear of the TrailCheck until the
Status Indication starts flashing
ORANGE
(approximately 5 seconds)
The TrailCheck can be unplugged when not in use and will not require repeating the
pairing sequence when reused.
5
Summary of Contents for TrailCheck
Page 1: ...TEAMBMPRO COM OWNER S MANUAL TrailCheck ...
Page 11: ...11 ...