13
SW-DW Stove Pipe Starter Section
This component is used to connect from a vitreous enamel or stainless steel single
wall connecting flue pipe to ICID Plus. The protruding liner should be pushed
down inside the female socket of the connecting flue pipe and the joint sealed with
fire cement or high temperature sealant to provide a gas tight joint.
Please note that when a single wall connecting flue pipe is used to connect to the
starter section, the joint between these two components must be a minimum of
425mm below the ceiling in accordance with BS EN 15287-1. This component
MUST only be fitted to stove pipe and NOT directly to appliance.
SW-DW Adjustable Starter Section
The protruding male spigot of the adaptor slides down inside the female socket of the Prima Smooth pipe and the
socket of the Prima Smooth pipe slides within the conical section of the starter adaptor, to a maximum length of 75mm
into the cone with a minimum of 15mm to ensure a secure connection.
This maximum length of 75mm will leave sufficient space within the adaptor to allow for thermal expansion of the
single wall pipe and also to allow for the connecting flue pipe to be removed without cutting, if the appliance has to
be moved for servicing.
This component MUST only be fitted to stove pipe and NOT directly to appliance.
SW-DW
Stove Pipe
Starter Section
100
15 min
75 max
Prima Smooth
SW-DW
Adjustable
Starter Section
