635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721
Page 5 of 8
Section 4 – Mounting the Stone Continued
2.
It is a good idea to have someone spot you on the position of the bracket and to see if you are centered or
not inside the basin. Lift the stone up just past the mounting cleat and tip the top back so it is just under the
disperser (E) and then tilt the bottom back towards the wall clearing the reservoir lip. Lower the stone until
it engages the cleat. Make certain the stone is well seated on the cleat and centered from left to right inside
the reservoir (L).
Section 5 – Setting the Disperser and Diffuser
1.
Gently lift the disperser (E) from behind the bracket template (A) and slide the template out from behind the
stone wall bracket (A). Slide the tabs on the disperser (E) behind the stone and into the pocket clips on the
stone wall bracket (B). The disperser (E) should sit evenly along the angle on the stone edge. Press the
disperser (E) down firmly to ensure there are no gaps between it and the stone. Center the Disperser (E) on
the stone.
2.
Drop the water diffuser (F) directly over the center of the disperser hole. The diffuser (F) will clip on the back
edge of the disperser (E). Make certain the diffuser (F) is sitting directly over the hole.
3.
During the installation of the stone the plumbing connection may have moved behind the stone. Gently lift
the bottom edge of the stone and pull the plumbing down so it is resting in the reservoir (L). The vinyl
tubing should be inside the rounded bump out in the reservoir (L) so the weight of the stone does not pinch
it closed.
4.
Connect the pump (H) to the plumbing using the quick connect fitting.
