635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721
Page 6 of 8
Section 6 – Installing the Header and Shroud
1.
Locate the Header and Shroud (G). Install the Header by simply sliding it into the support clips located on
the stone wall bracket (B). It may be a very tight fit so you may need to pull the disperser forward to allow
for the header to slide down into the clip. Take a few steps back looking at the fountain and make certain
the header is sitting level.
2.
Install the Shroud by carefully sliding it behind the panel and down onto the reservoir (L).
Section 5 – Installing the Light Kit
1.
Carefully unwrap the LED light bar (K). Take care
in handling so that the LED strips and
connections to transformers are not disturbed.
2.
Remove the tie from the electrical cord.
3.
Lay the LED light bar (K) on top of the header (G)
with the LED strip facing down. It is designed to
simply rest on the header (G). The back of the
light kit hangs down covering the castellated
stainless steel disperser (E). Make certain it does
not interfere with the water flow and does not
touch the disperser (E).
4.
Take the light cord and plug it into the
transformer. Drape the cord through the header
(G) and down the side where you will plug it in.
Tuck the exposed cord behind the stone so it is
concealed.
5.
You are now ready to use your LED light bar.
