NPA100DA
USER MANUAL
www.blustream.com.au
|
www.blustream-us.com
|
www.blustream.co.uk
14
System Page:
The System page allows users to change the system configuration of the NPA100DA such as:
•
Key Lock On/Off - enable or disable to front panel keys from functioning
•
Power On/Off - turn the unit on or off
•
Input Trigger On/Off - enable or disable input trigger function
•
CEC Volume Control On/Off - enable or disable CEC volume control to allow a television remote to control the
volume of NPA100DA
•
Power Mode - if the NPA100DA is connected to DC power supply, then PoE power modes will not be selectable. If
the NPA100DA is connected via PoE, it will default to the minimum PoE power specification (PoE+ Type 2 Class 4). It
is recommended to set this to the PoE power specification of the PoE adapter powering the NPA100DA
•
Front Panel Lights - enable or disable the front panel LED lights, or set them to time out after a specific time (15, 30
or 60 seconds)
•
Serial Baud Rate - specify the baud rate of the serial RS-232 port on the device
•
Auto Standby Time (minutes) - specify the time in minutes where the unit will enter standby mode if no audio
signal is being received on the selected input (default is 10 minutes)
•
Firmware Update - allows a user to update the firmware of the device
•
Factory Reset (Excludes Network Settings) - factory defaults all settings except for network configuration
•
Factory Reset (Includes Network Settings) - factory defaults all settings including network configuration
•
Reboot - power cycles the unit without changing any configuration settings
