blupura WAVE I.T., Use & Maintenance Manual

Page: 14 / 36

14
Functions of the volumetric keypad
The TOUCH VOL watercooler is provided with a TOUCH SCREEN PANEL (Fig.
13.1) with 4 back-lit commands. 3 commands control the supply of water, 1
controls the stand-by (ENERGY SAVING function, P.4).
When the appliance is turned on an automatic visual test of the ALARM LED (L.1)
lights up in sequence followed by the supply commands (P.1 – P.3).
The water cooler (both mod. TOUCH VOL and I.T. VOL) is equipped with
a VOLUMETRIC dispensing system. The dispensing quantities are easily
PROGRAMMABLE during installation and it’s possible to set two quantities for
each button. On turning on the unit, the default settings are as follows: a short
push of the button dispense 200 cc (a cupful) of water, whereas a long push
dispense 1000 cc (1 litre).
BUTTON FUNCTIONS:
- SPARKLING WATER DISPENSER button (P.1)
- ROOM-TEMPERATURE WATER DISPENSER button (P.2)
- COLD WATER DISPENSER button (P.3)
While the water is being dispensed, the LED turns itself off. You can stop the
dispensing process at any time by pressing the button again.
SETTING THE QUANTITIES:
Thanks to the Volumetric dispensing functionality, you can customize the pre-set
quantities dispensed by each of the 3 buttons. Normally, a SHORT push of the
buttons used for the dispensing of small quantities, with a LONG push being
used for the dispensing of larger quantities. The default settings are 200 cc for a
short push and 1000 cc (1 litre) for a long push.
To enter the programming mode, press and hold (for > 4 seconds) the following
combination of buttons: P.4 + P.2 (Energy Saving “Room temperature”
button). When you enter the programming phase, you will hear three consecutive
beeps.
In this phase, the LED of button P.4 (Energy Saving) and the LEDs of the
dispensing buttons (TOUCH VOL mod.) or the GREEN led L.3 (I.T. VOL mod.) start
to flash.
To set the maximum dispensing limit for a specific button, press the button in
question to start the dispensing process: : a SHORT push for the dispensing of
* Functions of the“Touch Control” keypad. All of the
operations must be carried out exclusively by qualified
technical personnel. To view the video tutorial, scan the
QR code.