Blumfeldt 10034882, Manual

Page: 36 / 40

36
EN
Pour glass beads fully to cover the whole burner before operation.
1. Turn the control knob to the “OFF” position (Figure a).
2. Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for
10 seconds to purge air from gas lines before proceeding.
3. Push in gas control knob and turn counterclockwise to “IGNITER” (Figure
b) to light the fire pit. If needed, keep depressing and turning control
knob counterclockwise until the heater lights (You should hear a clicking
sound).
4. After fire pit lights, release control knob. Push in and turn the control
knob to the “HIGH”, then release control knob. If you want a lower
temperature, push in the control knob and turn clockwise to the “LOW”
(Figure c).
Note: If burner fails to remain lit, all valves should be closed and a waiting
period of at least 5minutes should pass before attempting to light.
To turn on the fire pit
1. To extinguish burner depress control knob and continue to turn it
clockwise to OFF.
2. Turn cylinder valve clockwise to OFF and disconnect regulator when fire
pit is not in use.
Figure a
O
P
FF
ush
to
tu
rn
LOW
H
IG
H
E
T
G I
I
N
LOW
H
IG
H
LOW
H
IG
H
Figure b
OFF
Pus
h
to
tu
rn
E
T
G I
I
N
Figure c
OFF
P
h
us
to
tu
rn
E
T
G I
I
N